Touch RGB 2 Controller

The case is made of durable plastic ABS 

Power connection is carried out in two alternative ways: the connection of terminal or power connector. 

Options: 
RGB controller, radio remote control (5 buttons + sensor ring). 
Remote Power: Battery type AAA - 2 pcs (not supplied). 

management: 
Button 1 ON / OFF - ON / OFF. 
Button 2 Mode - switch 15 modes 
3 Button White - Select White / output color selection mode. 
Button 4 Brightness Up / Speed ​​UP - dimming / decrease speed in dynamic mode 
Button 5 - Brightness DOWN / Speed ​​DOWN increase brightness / speed increase in dynamic mode 

instructions: 

1.Press the button 1 to turn on / off 

2.Press the button 2 to switch between color changes. 

3.Press the button 3 once to activate white light. Changing the brightness in this mode, the white by using the buttons 4 and 5 Press 3 again to exit to the color selection. In the color picker choose the color by touching the corresponding segment on the touch ring, brightness control using the buttons 4 and 5. 

4.When the power is turned off the display reverts to that was before. 

5.VNIMANIE: Initially, you may need to configure the remote to the receiver. This will require immediately after the power supply to the receiver, hold down the button for 3 seconds 4on. Connected to the receiver of lights (eg LED strip) must do three flashes, it means that the communication between the receiver and the remote control is set. 
To delete the established connection between the receiver and the remote control is necessary after power to the receiver, press the 4 button on the remote five times in a row, then light unit connected to the receiver should make 6 light flashes - it means the connection of the receiver and the remote is removed. 

modes: 

1. Automatic change of all colors; 

2. Three colors change abruptly; 

3.Sem colors change abruptly; 

4.Tri colors change gradually; 

5.Sem colors change gradually; 

6.Krasny color flashes; 

7.Siny color flashes; 

8.Purpurny color flashes; 

9.Zeleny color flashes; 

10.Zhelty color flashes; 

11.Tsian flashes; 

12.Bely color flashes; 

13.Smena red and blue; 

14.Smena green and blue; 

15.Smena red and green colors. 

In modes 1-12 buttons 4 and 5 control the brightness, modes 13-15 4and 5 buttons control the speed of the color change. 

!!! Attention !!! Do not touch the sensor ring during replacement to avoid a deterioration of the sensor. Use the remote control is not earlier than 3 seconds after the batteries are installed. If the sensor ring has lost sensitivity, remove and reinsert the battery. 

Application: 

Used to control RGB LED strips, modules, arrays, spotlights. Powered by a power supply 12-24VDC, signal amplification using RGB signal amplifier. Control via the remote control. 

 

Specifications:​

Dimensions Controller, mm​ 85х45х23
Dimensions panel, mm 115x55x19
Voltage​​ 12-24V DC​
Current, A/m​​ 18А(3x6А)
Communication​  30м
The frequency of the radio signal​ 2,4Ггц