Touch Dimmer "Touch Dim 1A"

The case is made of durable plastic ABS 
Power connection is carried out in two alternative ways: the connection of terminal or power connector. 

Options: 
Receiver-dimmer, radio remote control (5 buttons + sensor ring). 
Remote Power: Battery type AAA - 2 pcs (not supplied).

management: 
Button 1 ON- inclusion. 
Button 2 OFF - Switches. 
Button 3 - The maximum level of brightness. 
Button 4 - The average level of brightness. 
Button 5 - minimum brightness level. 

Touch Ring for precise, smooth adjust the brightness (50urovney). 

* When switching-power-mode is restored, which was before. 

NOTE: Initially, you may need to configure the remote to the receiver. This will require immediately after the power supply to the receiver, hold down the button for 3 seconds 3. Connected to the receiver of lights (eg LED strip) must do three flashes, it means that the communication between the receiver and the remote control is set. 
To delete the established connection between the receiver and the remote control is necessary after power to the receiver, press the 3 button on the remote five times in a row by 3 seconds, then the light unit connected to the receiver has to do 6 

!!! Attention !!! Do not touch the sensor ring during replacement to avoid a deterioration of the sensor. Use the remote control is not earlier than 3 seconds after the batteries are installed. If the sensor ring has lost sensitivity, remove and reinsert the battery.

Application: 

Used to control LED strips, modules, arrays, spotlights. Powered by a power supply 12-24VDC, signal amplification using a signal booster. Control via the remote control.

Specifications:​

Dimensions Controller, mm​ 85х45х23
Dimensions panel, mm 115х55х19
Voltage​​ 12-24V DC​
Current, A/m​​ 12А(2x6А)
Communication​  30м
The frequency of the radio signal​ 2,4Ггц