Touch RGB 3 Controller

The case is made of durable plastic ABS 

Power connection is carried out in two alternative ways: the connection of terminal or power connector. 

Options: 
RGB controller, radio remote control (5 buttons + sensor ring). 
Remote Power: Battery type AAA - 2 pcs (not supplied). 
instructions: 

 

management: 
1. ON- inclusion. 
2. OFF-off switches. 
3 color touch circle - to choose static colors glow. 
4 Indicator light touch sensors. 
5 Faster color change / flicker / flashing. 
6 Increase brightness. 
7 Reducing the brightness. 
8 Reducing the rate of color change / flicker / flashing. 
* When turning the power is restored regime that was before. 
NOTE: Initially, you may need to configure the remote to the receiver. This will require immediately after the power supply to the receiver, hold the sensor 5 for 3 seconds. Connected to the receiver of lights (eg LED strip) must do three flashes, it means that the communication between the receiver and the remote control is set. 
To delete the established connection between the receiver and the remote control is necessary after power to the receiver, press the remote sensor on the 5 five times in a row, then light unit connected to the receiver has to do 9 light flashes - it means the connection of the receiver and the remote is removed. 
The remote can control an unlimited number of signal receivers. 
The signal receiver can be operated simultaneously with up to four remotes. 
modes: 
1 White constantly lit; 
2 White flashes slowly; 
3 All the colors change gradually; 
4 Three Colors vary smoothly (green, blue, red); 
5 Seven colors change abruptly; 
6 Three colors change gradually; 
7 Change of red and green irregular; 
8 Change of red and blue irregular; 
9 Change of green and blue irregular; 
10 White flashes; 
11 White flickers; 
12 red flashes; 
13 red blinks; 
14 green flashes; 
15 Green blinks; 
16 Blue color flashes; 
17 Blue color flickers; 
18 Yellow flashing; 
19 Yellow flickers; 
20 All of the modes are changed sequentially in a circle. 

In all modes available change brightness and flicker rate / change colors. 
!!! Attention !!! Do not touch the sensor ring during replacement to avoid a deterioration of the sensor. Use the remote control is not earlier than 3 seconds after the batteries are installed. If the sensor ring has lost sensitivity, remove and reinsert the battery. 
Do not short-circuit on the receiver source- it can ruin it. 
Do not use the remote control in high electrostatic voltage - it can ruin it. 

Application: 
Used to control RGB LED strips, modules, arrays, spotlights. Powered by a power supply 12-24VDC, signal amplification using RGB signal amplifier. Control via the remote control. 

 

Specifications:​

Dimensions Controller, mm​ 85х45х23
Dimensions panel, mm 110x52x20
Voltage​​ 12-24V DC​
Current, A/m​​ 18А(3x6А)
Communication​  30м
The frequency of the radio signal​ 2,4Ггц